Yes, I am trying to get the tracing pattern down. However, I have no parts to go from so getting exact angles is a little problematic. Also, since I am not making a full size cab (yet), purchasing the reproduction sideart at this point is a little much. This is why I'm relying on the kindness and graciousness of people like yourselves to help me.
The pictures you provided are great(!!!) and I thank you very much for them! Using the pictures that you provided would be extremely useful for someone who has parts as a guide. However, I don't have the individual parts to guide me, and the proportions are skewed from the angle of the camera. As you can tell from the pictures, the right angles at the bottom of the cabinet aren't square. Therefore, I can't use them to even eyeball the distances needed. I could try using Photoshop to make them square, but the proportions on the other parts of the cab would be changed as well. Unless someone gets a straight on perpendicular camera shot from a 50 meters away and zooms into the size of the cab, the proportions are always going to be "off".
There's also measurements that I don't have at all like speaker grill cut outs, air holes, etc.
The goal of this project, once I figure everything out, is to shrink the cabinet proportionally to ~75% of it's original size. If this all goes well, and I *do* have all the correct measurements, I could look into putting the full size cabinet measurements into a drawing program like the cabs on jakobud.com or even building plans like Kyle Lindstrom's amazing documents.
Again, thank you everyone for your help. Hopefully, you all will still like to help me since I might need more help later.
TAG
