need diagnosis help (DK jr video)

[RAPBIGICP1]

I'm in need of a little help diagnosing a video problem with my recently acquired Donkey Kong Jr. I'm having rolling/scrolling lines of video that are mostly blue.  I've cleaned and re-seated 2E & 2F.  I've ordered a cap kit, but it won't be here until tomorrow.  I'm hoping the cap kit will do it, but I'd like to be prepared if it doesn't.  There's a 2:19 video here:
http://www.youtube.com/watch?v=H7vwZJ28Juw

Any and all help appreciated!
& Pictures:

[Laschek]

Did you try to adjust sync? Is it an original board in an original cab with an original Nintendo type monitor?

[RAPBIGICP1]

Did you try to adjust sync? Is it an original board in an original cab with an original Nintendo type monitor?

No - (How?)
Yes
Yes
Yes

[Laschek]

Find the V-Hold (vertical) and H-Hold (horizontal) pots on the monitor chassis and try to "catch" the rolling picture. Beware, high voltage!
I don't know that much about those Nintendo monitors, don't some of them have a switch to choose between positive/negative sync? If so, try that one as well.

[RAPBIGICP1]

Pulled the monitor today.
Yanked (carefully) the boards out of it, and capped the Audio Amp as well as the main monitor board.  I also did the neck board pots, and extension board pots.
Hopefully I can get it all back together and start adjusting/tweaking soon... and then playing!!!!  *crosses fingers*

[RAPBIGICP1]

Cap kit done, monitor re-installed.  After some minor adjustment, it looks really good!!  Just one last bit to work out.  Any suggestions on how to fix?



Hmmm....  it doesn't appear as though there is a picture up there ^
Well, if you can see it, great.  If not, it can be seen here:
http://www.flickr.com/photos/lanceb/4996240860/
but basically, the left side of the screen (about a half inch or so) is being pulled straight down by about an inch and a half (4cm?).
It's not horrible, but I'd like to do away with it.

Suggestions?

Thanks!