WTB - vertical/horinzoal daughterboard, as used in the WG K4600 serie

[ckong]

The title says it all. It must be in good working order of course. The one that I have and which was in the Qix, has vertical collapse issues. I now borrowed a daughter board from the old pac-man monitor, so I need another one, working. I just need the daughterboard, not a whole chassis.

Oh, and a horizontal width coil for a WG19K6... is also welcome.

[Superully]

do you have a pic of what you are looking for?

[ckong]

yep

[Etienne MacGyver]

If another is working, why not rebuild the broken one ?

[ckong]

They both have issues. No one has a leftover/parted out H/V daughterboard?

[level42]

Hey, it's such a small print....and vertical collapse......likely a soldering, or a bad transistor or cap...

There's just a handful of them on that board...should be fixable. You can send it to me and I can do a quick check on caps, transistors and solderings and send it back.

Not 100% I will find something but....worth a shot. I will offer this to you my friend, as a little bit of consolation for not getting that awesome Midway coin-door plate....

I think it's not very likely someone will have spare boards for this monitor.

[ckong]

Thanks for the offer,  will keep it in mind.  But to further develop my electronics knowledge I also am trying some stuff out.  Caps are on both boards OK,  I replaced the old ones for new ones. Solder joints are also OK.   Diodes are OK,  at least I get the expected readings on most of them. Although,  there is one diode, x303, which has a reading that is much lower than the reading of the other diodes,  but the reading for this diode is on both boards the same.  And there are two diodes,  x305 and x306, which show the same reading on the open side as on the closed side.  One would say that these diodes fail,  but on the other daughterboard the diodes act the same.

I am now doing some tests with transistors.